+32 (2) 410 25 03
Flexible post TRAFFIFLEX - new generation

Flexible post TRAFFIFLEX - new generation (Art: 10-1000-008)

€--,--
1600
Article number: 10-1000-008
Email us about this product

Flexible bollard TRAFFIFLEX - new design

Reboundable delineator post with twin HI reflective bands

  • Manufactured from HDPE/EVA
  • Rebounds to its original form without damage after a collision
  • Easy to install with our installation key (not included)
  • Fitted with twin High Intensity reflective bands (type 2)
  • Coloured throughout the mass and UV resistant - choice of red or yellow
  • Contributes to increased road safety
  • Fully integrated galvanised steel base plate and bolt

 

Red bollard:      article 10-1000-008
Yellow bollard: article 10-1000-005
Green bollard:  article 10-1000-007
 
Our flexible bollard TRAFFIFLEX was thoroughly redesigned after more than 20 years. The composition of HDPE and ethylene copolymer has been updated so that the new reboundable delineator is much more flexible than the old version and returns better to its original form after a collision. The galvanized steel base plate and fixing bolt have become a single component that is now completely integrated into the the flexible bollard's body The flexible delineator is equipped with High Intensity reflective bands as standard and is supplied with the threaded wire sleeve (ground anchor) included.
 
Flexible bollards remain an efficient traffic guidance management system to protect vulnerable parts of the infrastructure. They are easy to install using a good drill, chemical anchor and an installation key M12. You will also find a specially designed installation key at Traffimex if you need to install larger quantities of flexible bollards.
 
During the installation, make sure that the steel base plate and bolt of the bollard are correctly positioned in the middle of the flexible delineator. It is best to screw the installation bolt into the threaded sleeve almost to the end, but to leave just enough clearance so that you can perfectly center your flexible bollard. Then screw the bolt tight until the bottom is firmly clamped between the ground surface and the steel base plate.
 
A matching coloured sealing cap is supplied with each flexible post. This allows you to close the opening at the top neatly after installation so that no dirt or debris ends up inside the flexible delineator. The sealing cap is firmly wedged in the opening and it may take a bit of effort to position it correctly. It will be a lot easier if you warm the cap a bit or rub it with a little lubricant.
 
Because the flexible beacon TRAFFIFLEX is made from a mixture of HDPE and a very smooth ethylene copolymer it bends effortlessly upon impact and then restores itself just as easy back into its original shape. The softness of the material also ensures that it will cause no or minimal damage to vehicles.
 
With a diameter of 20 cm this flexible delineator gives a robust impression which unconsciously results in greater vigilance among drivers. The perception of a larger obstacle brings greater caution and thus increases road safety.
 
That is why our flexible bollard TRAFFIFLEX is an absolute must
0 stars based on 0 reviews
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »